Prev

Next

Index-> contents reference index search external

Up-> CppAD AD BoolValued Compare

Headings-> Syntax Purpose Op x y b Operation Sequence Assumptions Example

@(@\newcommand{\W}[1]{ \; #1 \; } \newcommand{\R}[1]{ {\rm #1} } \newcommand{\B}[1]{ {\bf #1} } \newcommand{\D}[2]{ \frac{\partial #1}{\partial #2} } \newcommand{\DD}[3]{ \frac{\partial^2 #1}{\partial #2 \partial #3} } \newcommand{\Dpow}[2]{ \frac{\partial^{#1}}{\partial {#2}^{#1}} } \newcommand{\dpow}[2]{ \frac{ {\rm d}^{#1}}{{\rm d}\, {#2}^{#1}} }@)@This is cppad-20221105 documentation. Here is a link to its current documentation . AD Binary Comparison Operators
Syntax
b = x Op y

Purpose
Compares two operands where one of the operands is an AD<Base> object. The comparison has the same interpretation as for the Base type.

Op
The operator Op is one of the following:

Op	Meaning
<	is x less than y
<=	is x less than or equal y
>	is x greater than y
>=	is x greater than or equal y
==	is x equal to y
!=	is x not equal to y

x
The operand x has prototype
    const Type &x
where Type is AD<Base> , Base , or int.

y
The operand y has prototype
    const Type &y
where Type is AD<Base> , Base , or int.

b
The result b has type
    bool b

Operation Sequence
The result of this operation is a bool value (not an AD of Base object). Thus it will not be recorded as part of an AD of Base operation sequence .

For example, suppose x and y are AD<Base> objects, the tape corresponding to AD<Base> is recording, b is true, and the subsequent code is
    if( b )
        y = cos(x);
    else
        y = sin(x);
only the assignment y = cos(x) is recorded on the tape (if x is a parameter , nothing is recorded). The CompareChange function can yield some information about changes in comparison operation results. You can use CondExp to obtain comparison operations that depends on the independent variable values with out re-taping the AD sequence of operations.

Assumptions
If one of the Op operators listed above is used with an AD<Base> object, it is assumed that the same operator is supported by the base type Base .

Example
The file compare.cpp contains an example and test of these operations.

---

Input File: include/cppad/core/compare.hpp